tolerances in A Sentence

    1

    Standard Tolerances: ±5%, ±10%, ±20%.

    0
    2

    Common range of Tolerances.

    0
    3

    Other Tolerances available upon request.

    0
    4

    Triple-layer Bushing General Tolerances:.

    0
    5

    Dimensions, sizes, shape and drawing with Tolerances.

    0
    6

    Standard Tolerances for neodymium magnets are+/-.

    0
    7

    (designs with tighter Tolerances available upon request).

    0
    8

    Nominal Shaft Diameter Tolerances.

    0
    9

    Special dimensions and Tolerances are available upon requests.

    0
    10

    Tight Tolerances with rollers.

    0
    11

    Closer Tolerances can be agreed on.

    0
    12

    Tight Tolerances can be achieved by precision CNC Machining.

    0
    13

    Ultimately, the final design must handle the extremes of Tolerances.

    0
    14

    Tolerances: ground, lapped and polished surfaces in the μm range.

    0
    15

    Tolerances: Normal, with O/D over 420 mm the running accuracy is P6.

    0
    16

    Parts, which demand tight Tolerances, also contribute to the mold complexity.

    0
    17

    The final process of selecting a ring must be in accordance with the Tolerances.

    0
    18

    These Tolerances can be read on the clutch on the power unit side.

    0
    19

    Dimensions and geometry, Acceptable dimensional Tolerances, Stress/ load requirements, Machining requirements, Non-destructive test requirements.

    0
    20

    Boron Nitride can easily be machined to close Tolerances in virtually any shape.

    0
    21

    Dictate the production method to be used and thus the cost. Close Tolerances frequently.

    0
    22

    Accuracy and surface roughness Tolerances can outperform injection-molding and even compete with CNC.

    0
    23

    Specializing in the machining of components with tight Tolerances that others can't make.

    0
    24

    Note: For the finished seamless steel tubes the Tolerances No.1 shall be applied.

    0
    25

    Profiles and Tubes are cut to length-cut-off Tolerances and angular erros are compensated by.

    0
    26

    While Tolerances within 0.07% are available, the most widely used Tolerances are 5% and 10%.

    0
    27

    Within 10 times the depth of the machined hole, better Tolerances can be guaranteed.

    0
    28

    While Tolerances within 0.07% are available, the most widely used Tolerances are 5% and 10.

    0
    29

    Dimensional Tolerances can only apply to two of the three tubing dimensions( OD, ID, or wall).

    0
    30

    Compared to convertional hot rolled steel tube, this material offers superior Tolerances, a smoother, scale-free.

    0


Related Words

non-specialists in a sentencemost-watched in a sentencerabbitmq in a sentencecompo in a sentencemultiplex in a sentenceshubhbank in a sentencedyes in a sentencehardcap in a sentencenucleons in a sentencepremiums in a sentenceibibo in a sentencefinger-like in a sentenceelizabet in a sentencecrochets in a sentencetravelog in a sentenceundramatic in a sentenceyul in a sentenceboasting in a sentencemythili in a sentencewikiquote in a sentence