Above this squared architrave were laid the joists of the ceiling, and those of the floor upon the layer of ashes.
Among the ancients it was in request for poles, rafters, joists, and for the construction of winepresses, tables and musical instruments; and on that account was so valuable that a plantation of cypresses was considered a sufficient dowry for a daughter.
As a substitute for timber props at the face, pieces of steel joists, with the web cut out for a short distance on either end, with the flanges turned back to give a square bearing surface, have been introduced.
Attach the fan brace by slipping it through the hole in the ceiling and positioning it so that it touches the joists on both sides of the hole.
Before you start putting up drywall, make sure all of the plumbing and wiring through the wall joists are completed.
Check for joists before you make your initial cut and arrange the spacing accordingly.
Check the flooring - Even though you have to install a setting bed, check the flooring construction underneath the tub (floor joists, sub flooring etc.,) before installing your new tub.
Find the locations of your studs or joists and mark them.
First, he made a number of leathern tubes the ends of which he contrived to fix among the joists and flooring of a fine upper-room in which Zeno entertained his friends, and then subjected it to a miniature earthquake by sending steam through the tubes.
Floor joists are dropped between both trimmer joists in hangers to span the loft area.
For example the new joists must not touch the original ones.
For shaft linings steel rings of H or channel section supported by intermediate struts are also used, and cross-bearers or buntons of steel joists and rail guides are now generally substituted for wood.
I now want to insulate between the joists and still leave part of the joists exposed.
If the loads to be carried are largely stationary, and if the span is small, the floor joists can be readily proportioned by means of tables given in the handbooks issued by many steel companies.
If you plan on doing this, you should set this insulation at a perpendicular angle to the joists.
In large levels only the cap pieces for the roof are made of steel joists, but in smaller ones complete arches made of pieces of rails fish-jointed at the crown are used.
In the case of a timber joist floor the floor joist floor the floor joists should be tied to the walls by means of steel ties.
In the Matrai system thin wires are used instead of rods, and are securely fastened to rolled steel joists, which form the beams on which the slabs rest; moreover, the wires instead of being stretched tight from side to side of the slab are allowed to sag as much as the thickness of the concrete will allow.
Install the joists - After you have finished installing the posts, install the joists.
Joists that run parallel to the molding provide an anchor.
Keep your feet on the joists or you may accidentally put your foot through the ceiling below.
Only the perimeter joists and rafters may be included in bracing and blocking.
Over time, this will weaken the sub flooring and floor joists beneath the tub.
Plank ceilings are installed directly to furring strips or exposed joists with clips and screws.
Run the lift up so that the sheet is positioned in place perpendicular to the ceiling joists.
Simply add the insulation between the ceiling joists and spread it with a rake.
Small squares of soundproofing mat can also be used behind the resilient bars where they are attached to the joists.
Take the time to find the studs or joists first and mark them off on the ceiling.
The " roods " themselves were not The simplest form is the " flat roof " consisting of horizontal wood joists laid from wall to wall as in floor construction.
The deck support joists are then fixed to the ledger board using joist hangers.
The distance between joists should be limited to 5 or 6 ft.; horizontal bracing by means of diagonal rods is sometimes used, but should be avoided.
The existing ceiling joists are not designed for heavy loads.
The joists are covered with a waterproof material such as asphalt, lead, zinc or copper, the three last materials being usually laid upon boarding, which stiffens the structure and forms a good surface to fix the weatherproof covering upon.
The larger trees are sawn up into planks and battens, much used for the purposes of the builder, especially for flooring, joists and rafters.
The roof joists were rotten; the first floor walls were down to the window ledges.
The spaces for the floor joists can be clearly seen.
The system solves all the inherent shrinkage problems associated with solid timber joists.
The track will have to be mounted to your wall or ceiling, and although most fixtures are lightweight, check the location of your studs or ceiling joists relative to where you'll be mounting the track light.
There must be holes in any dividing walls or the walls that support the joists under the floor.
To keep the plastic in place, use a staple gun and staple it at intervals to the floor joists.
Use the stud finder to locate the ceiling joists so you don't accidentally line a fixture up for installation in a spot where one is located because this can throw your entire installation off.
When fastening the plasterboard, the screws must be connected to the channels in-between the studs or joists.
While the decking is composite wood, the beams and joists underneath are still real wood and are subject to the usual conditions.
While you're up there, you should also check to make sure that the box is securely installed to the joists.
You will see that the timber beams have now been replaced by steel joists.
You'll generally place baffles at the intersection between the joists and the rafters.