joist in A Sentence

    1

    These marks indicate the center of each Joist.

    0
    2

    What Is a Metal Joist?

    0
    3

    Don't know what a Joist is?

    0
    4

    Ceiling Joists on the show?

    0
    5

    Joists placed 24” on center are usually adequate.

    0
    6

    Beneath this lining are timber Joists and bearers.

    0
    7

    Big frame Joist steel and A3 steel plate welding.

    0
    8

    The distance between Joists depends on several important factors:.

    0
    9

    Usually Joists are located so that their centers occur exactly every 16”, 24”, or 32”.

    0
    10

    Do a similar layout on the girder, so that you know exactly where each Joist crosses the girder.

    0
    11

    That work lasted two years and after another three years all the Joists and roof surfaces were finished.

    0
    12

    Even a seasoned professional can accidentally put the Joist and Joist hanger on the wrong side of the mark.

    0
    13

    To do this you need to make marks, called layout marks, on the ledger and girder that show where each Joist will be located.

    0
    14

    As long as the top and bottom fibers resist these stresses, the Joist will do its job of keeping the floor strong, straight and solid.

    0
    15

    The swing-down rafter hook lets you hang the saw from a Joist or rafter between cuts(and believe me, you will want to give your arm a break between cuts).

    0
    16

    Be sure as you go along that you are dear about which side of the mark the Joist hanger and Joist should be nailed to, to assure proper spacing.

    0
    17

    Pay special attention to any part of the deck that is in direct contact with the ground, such as the posts, stair stringers or Joists that are at ground level.

    0
    18

    Pay special awareness of any area of the deck that is certainly in direct experience of the ground, such as the posts, stair stringers or Joists which can be at ground level.

    0
    19

    Again, draw new lines 3/4" to one side of the center line(the same as you did for the ledger) and then make an“X” so that you will know on which side of this line the Joists will finally sit.

    0