Any board designed to use these shields
will have to have the exact footprint and Pinout as Arduino.
The loom covered with braiding sleeve for protection in machine, and every Pinout and branches marked with label.
And although the Pinout is almost identical to the of Raspberry PI3
We must adapt our projects to migrate to Odroid.
(No soldering, no Pinout reviewing, no pin counting,
saves lots of time and hassle and let's you make your job faster, precise and easier).
We must bear in mind that in this diagram,
WRTNode It is photographed by the solder side so make us connections must invest the Pinout.
When creating a module with the Gadgeteer standard Pinout, you are making something that will be accessible to everyone,
no matter what system they have.
Total offers of 78 GPIO pins, and the following table extracted from the wiki's WRTNode,
We can see the Pinout of each and every one of them;