floodcheck in A Sentence

    1

    The Floodcheck ® Auto Valve.

    0
    2

    Q Is there a warranty on Floodcheck® Auto?

    0
    3

    The Floodcheck® will also switch off the water automatically for the following reasons;

    0
    4

    Floodcheck® must be installed by a competent person and should be tested for correct operation periodically.

    0
    5

    The first thing to check if the water is not working, are the“Warning LEDs” on the Floodcheck® Auto Valve,(not the water control switch).

    0
    6

    A These are installed before the Floodcheck primarily to reduce lime scale build up and prevent any ferrous particles entering the valve and getting lodged inside.

    0
    7

    When installing Floodcheck devices the use of putty type sealants e.g. Plumber's Mate is NOT recommended(or needed), if used it can potentially block the filters or cause failure of moving parts.

    0
    8

    We suggest installing the Floodcheck 60mm from the stopcock to allow for cutting of the pipe and fitting of the Ring Magnet, however It is not critical to fit at this distance.

    0
    9

    The Floodcheck® is set at the factory to cut off the water should continuous flow be sensed for over 15 minutes, however this time can be adjusted to meet your needs up to maximum of 40 minutes.

    0
    10

    One of the most common reported fault that we receive is that“the water appears to have gone off for no reason”, thankfully this is rarely the case and there is normally a perfectly good reason why the Floodcheck® has stopped the water flow“Floodcheck is doing its job”.

    0