Tie each Armhole according to scheme 2.
Repeat Steps 1 and 2 for the other Armhole.
When the Armhole is formed, the hinges both lower and close.
Ease the Strap & Binding around the Armhole and pin in place.
On the Armhole, the reductions are made at the beginning of the row.
First, the Armhole of the sleeves is knitted,
then it is already rolled over;
Modeling Armhole loops are reduced either inside the row or along the edges.
Single-breasted jackets with two slots and a high Armhole neatly fit the chest.
Pin and stitch the partial SLEEVE Armhole seam allowances to the FRONT and BACK.
The Armhole is loose,
at the waist a narrower jacket, lapels slightly moderate in width rounded.
The height of the Armhole from the shoulder seam to a hand's breadth below the armpit.
Pin and stitch the Armhole and neckline front facing to the front garment piece, RIGHT SIDES together.
Begin by cutting 3 strips of fabric on the bias 4.5cm wide and
a little longer than the Armhole.
Then pin to either side of the Armhole then ease the rest into the Armhole. Finish the seam.
The final stage is the grinding of the side seams and the treatment of the Armhole and the bottom.
After 2 cm from the Armhole, begin to perform a decrease at the beginning and at the end of the next persons.
Then knit straight until the sleeve length to the Armhole is 37(38)
39(40) cm(remember that the height of the Armhole is large enough).